How We Build
Five Steps. No Shortcuts.
Most coating failures are prep failures — peeling, bubbling and delamination almost always trace back to a slab that was never mechanically opened. We never skip a step.
- 100% Commercial-Grade Materials
- UV & Slip Resistant
- Free On-Site Estimates
- Warranted Workmanship
Diamond Grinding & Mechanical Prep
Industrial diamond grinders open the concrete profile to CSP 2–3 with HEPA dust containment. This is what guarantees a 100% mechanical bond — no acid etching shortcuts, ever.
Joint & Crack Repair
Every crack, spall and control joint is chased, vacuumed and filled with a rigid polyurea repair compound, then re-ground flat to restore structural integrity.
Moisture Mitigation & Base Primer
We test slab moisture before a drop of resin is poured. Where vapor drive exists, a mitigating primer is applied so your floor never blisters or delaminates.
Custom Flake Broadcast or Metallic FX Design
Your finish is built by hand — full-broadcast flake to refusal, or troweled and torched metallic pigments blended on site to your approved design.
Polyaspartic Clear Topcoat
A UV-stable polyaspartic topcoat seals everything in: scratch resistant, chemical resistant, non-yellowing, and walkable within hours.
Free Estimate
Ready To Start Prep?
We'll assess your slab condition, moisture levels and prior coatings before quoting a system.